Solar Powered Bricks User's Manual
September 2005
Available Brick Surface Textures
Available Brick Surface Textures
Type No.: SPV-BLDZ-I |
Type No.: SPV-BLDZ-II |
Type No.: SPV-BLDZ-III |
Type No.: SPV-BLDZ-IV |
| A. Product Description
Our Solar Bricks are green and environment-friendly products. The light is powered by solar energy through a poly crystalline solar panel and a built-in AA Ni-MH HT battery. The solar panel converts sunlight into electric energy and then charges the battery during the daytime. Our Solar Bricks shoud be installed in locations where the best sunlight is available and the surface of the brick, where the solar panel is located is in the best direction to receive maximum sunlight. The light Source is from bright LEDs with super luminous intensity which can work up to 50 hours in the dark after a single day of charging in sunlight. B. Specifications Table |
|
|
|
| Solar Cell | Crystalline Silicon 3.84V/320mA |
| Storage Battery | Ni-MH HT AA 1.2V/3200mAh |
| Light Source (Super Luminosity LED) | Constant Type: 8 LEDs Varying Type: 18 LEDs |
| Luminosity Colors | Blue, Green, Red, Yellow and White |
| Luminosity Mode | Constant Type/Varying Type |
| Work time | up to 50 hours for each sunny day of charging |
| Operating Temperature | -4° F (-20°C) to 140°F (60°C) |
| Material of Main Body | Boron-Silicon Glass |
| Waterproof Grade | IP68 |
| Size | 200 x 200 x 50 mm (+/-2mm) (8″ x 8″ x 2″) |
| N.W. | 3.2 kgs |
| C. Diagram and Introduction
The light is weather-proof (meets IP-68 specifications) and contains the parts as shown in diagram a:
|
| D. Replacing the battery
If the light stops working after being
used for a long time, the battery may be beyond its lifespan. Unscrew the eight (8) phillips screws holding the battery lid in place and replace the expended battery with a new Ni-MH HT battery.
|
| E. Installation Instruction
Installation is very easy in soft soil. Just remove the magnet which keeps the brick in an off mode and install in a hole the same size and depth as the brick. .
If the ground is hard, please seal around the brick witha soft airproof glue and then install the same way you would if it were being placed in soft soil. For installation in concrete or asphalt, use the same methods (with a soft airproof glue) that you would in hard soil.
|
| F. Precautions
(1) Our illuminated bricks are designed to work when it is dark. If there is high ambient lighting near by, then the LED lights may be very dim or not turned on at all. (2) Although we charge the batteries before you receive your illuminated bricks, the pre-charged power level will most likely have diminished by the time you receive them. Please charge each illuminated brick for a full day to obtain maximum performance. (3) If you haven't used your illuminated bricks for a long period of time, please charge them for two sunny days. If you are not going to use them for an extended period of tme, replace the magnets in the bottom of the bricks in order to avoid any battery damage. |
|
L.I.F.E. Support Technologies ® |
|
For information, please contact us |
National Fire
Protection Association Member # 2311302 |
|
|
|
|
Developed by SALA-Publishing™ © 2004-2008 and beyond L.I.F.E. Support Technologies® |
